Pool Sharks Restoration - Playfield

This machine was given to me ( Well it cost a case of beer and a tank of fuel to pick it up ). The machine was in really bad condition - Look liked it had been sitting in a wet environment as it had extensive corrosion on most of the metal parts - However as I needed a SS machine to play and no money owing, I decided to spend the money just to get it looking decent and playable.
The playfield was in descent condition, no wear but very dirty, metal parts rusty, plastics warped. Cleaned up OK except dirt stains at mylar edges which I could not remove, did not want to risk removing the mylar and damaging the paint.
Drop Targets required a few new decals - Made them up using waterslide decals - The files can be found here Scans

Before

The metal ramp flaps were badly rusted and were replaced. The procedure can be found here Metal Ramp Replacement.
Here are some before and after shots.

After